To provide the best possible viewing experience please use Internet Explorer 8.0 or higher, Firefox, Chrome, or Safari.
The Magic Wand System is a compact sealing solution perfect for creating various sized and shaped packages.
Model MWS-I: Timed Impulse Heat
The sealing wire is activated by a push button switch which heats the wire to cut and seal the film being used. The heating cycle is determined by adjusting the seal timer on the power pack. Following one complete cycle, the sealing wire will cool until triggered again. This unit provides for greater sealing consistency as the timer controls the exact heat to the sealing wire during every heating cycle. Available in sizes: 24” & 36”
Model MWS-M: Manual Impulse Heat
The same system as the MWS-I except the operator controls the length of the heating cycle by depressing and holding the button switch. The unit is not automatically cycled off, but begins the cool down cycle as sson as the button is released. Available in sizes: 18”, 24”
Power Requirement: 115 Volt, 10 Amp., 60 Cycles, Single Phase Circuit with Ground
Wattage: 1,150 Watts
Working Height: Table Top
Aluminum Tables Available: 28” D, 44” W, 29” H; 43” D, 44” W, 29” H
Weight (Wand and Power Pack Only):
Impulse Heat: 14lbs. (6.35 kg);
Manual Impulse Heat: 9 lbs. (4.08 kg)
Warranty: 90 Days on Parts
Bryan Rakovec describing the setup and operating procedure of a manual model Magic Wand System.
The Magic Wand sealing system is used to splice film, this is done to avoid re-threading sealing and shrink systems.